
ServicesFrame Straightening
Frame Straightening in Lemoore
A hard hit can move the structure under your car even when the outside looks fixable. We measure your vehicle against factory dimensions, photograph what we find for your insurance claim and straighten it so the doors, wheels and safety systems line up again.
What frame straightening fixes
Most cars and small SUVs use a unibody design. The floor, rails and pillars are welded into one shell, so the body itself carries the load. Pickups and some bigger SUVs are different. Their body sits on a separate steel frame made of two long rails and crossmembers. A collision can bend either type, sometimes by a fraction of an inch and sometimes by several inches. You may not see it, but you can feel it in how the car drives and how the doors close.
Frame straightening means anchoring the vehicle, measuring known reference points underneath and pulling the damaged sections back to where the manufacturer built them. It comes before the dent work, the bumper and the paint. If the structure is off, everything bolted to it will be off too.
Some damage should not be straightened. Kinked rails and certain high-strength steels are meant to be replaced, not pulled. When that's the case, we tell you plainly and write it into the estimate so your insurer sees the same reason we do.
What the work includes
- Measurement before anything moves
- We check the underbody reference points and compare them to factory specs. That tells us which way the structure shifted and how far. It also gives your adjuster numbers instead of a guess.
- Photos and notes for your claim
- We photograph the damage before teardown and again as hidden damage turns up. You get a clear record of what was found. That helps when a supplement has to go to the insurance company.
- Controlled pulls
- The vehicle is clamped down and pulled in measured steps. We re-check between pulls so we don't overcorrect. Slow is the right speed for this.
- Repair or replace calls
- If a rail, apron or support is kinked or torn, straightening can leave it weaker. We'll show you why a part needs replacing and note it on the estimate.
- Final measurement
- Once the pulls are done, we measure again and confirm the points are back in spec. Then the car moves on to body work, paint and reassembly.
Signs your car may have frame damage
Gaps that don't match
Look at the space between the hood and fenders, or around the doors. If one side is wide and the other is tight, the body may have shifted.
Doors or trunk that fight you
A door that drags, a trunk that won't latch or a hood that sits crooked often points to a moved structure, not just a bent panel.
The car pulls or the wheel is off center
If the steering wheel sits crooked on a straight road after a hit, a suspension mount may have moved. An alignment alone won't fix that.
Uneven tire wear
Tires wearing on one edge soon after a collision can mean the wheels are no longer where they belong.
A hard hit to a corner or wheel
Sliding into a curb or a ditch on a rural road can bend things underneath with little damage up top. If a wheel took the blow, it's worth measuring.
What moves the cost of frame straightening
Two cars with the same dent in the bumper can need very different structural work. The price depends on how far the structure moved and what we find once parts come off. We'll walk you through the estimate and point out anything that could change.
How far it moved
A small shift at one corner takes fewer pulls than damage that runs back into the floor or a pillar.
Straighten or replace
Replacing a rail or support adds parts, welding and corrosion protection. Pulling a section that can safely be straightened costs less.
Unibody or full frame
Unibody cars often need more setup because the structure is part of the body. Trucks on a ladder frame have their own parts and access to deal with.
Hidden damage
Some damage only shows after teardown. When it does, we photograph it and add it to the claim before going further.
How a frame job goes at our shop
- 1
You bring the car in
We walk around it with you, ask how the collision happened and take photos. Bring your claim number if you have one.
- 2
We measure and write the estimate
We put the vehicle up, measure the structure and list what needs pulling and what needs replacing. You see the estimate line by line before work starts.
- 3
We work with the claim
We share the photos and measurements your insurer asks for. If more damage turns up during teardown, we photograph it and call your adjuster to get it added as a supplement. We explain each step, but the adjuster makes the coverage call.
- 4
We straighten and re-measure
The car is anchored and pulled back into spec, checked between each pull. Replaced parts are fitted and welded where the repair calls for it.
- 5
We finish the rest of the repair
Body work, paint and reassembly follow. We test doors, latches and how the car drives before we call you to pick it up.

Frame straightening questions
Will my car be safe after the frame is straightened?
When the structure is measured back to factory specs and damaged parts are replaced where they should be, the car can be returned to proper shape. The measurements are the proof, not our word. We'll show you the before and after numbers.
Does frame damage mean my car is totaled?
Not always. Your insurance company decides that by comparing the repair cost to the vehicle's value. We give them an accurate estimate and documentation, but we can't promise how they'll rule.
How long will the repair take?
It depends on how much moved and how quickly parts arrive. Waiting on insurance approval or a supplement can add time too. We'll give you an honest idea once the car is measured and keep you posted by phone.
Can every bent frame be straightened?
No. Kinked or cracked sections, and some high-strength steel parts, are meant to be replaced. We'll tell you which is which and why.
Will this show up on a vehicle history report?
That depends on what gets reported by the insurer, police or others, and it's outside our control. What we can do is give you a clear record of the repair to keep with your car.

Think the hit went deeper than the bumper?
Bring your vehicle in and we'll measure it, photograph what we find and explain what your insurance claim will need. We see drivers from Hanford, Armona and around Lemoore.